Went for a run again this evening and attempted to get the HR monitor to behave. You can tell it the HR range you want to stay in, and it will beep at you when you go outside this range, either above or below. I was doing 5min run, 1min walk and had switched the HR range off, so it shouldn’t have beeped at all. No chance! I’d do the 5min run, then slow down to walking pace whereupon the watch would stop as my HR was now too high for the recovery portion. I’d get it going again, then at the end of the walk I’d start the next run segment. Sure enough, the watch would stop because my HR was now too low for the run. I’ve just read the manual and it would seem that I’ve set everything up correctly, so a bit more research is needed methinks.

S: 5400m – B: 36.4km – R: 5.6km